![]() ![]() ![]() I've managed to get the header working (DX=stock_height, etc.) but I've stumbled on two other aspects. Haven't figured out how to change "X50" to "X=50" but I have done it in a separate application which is good enough for now. A post processor, sometimes simply referred to as a 'post', is the link between the CAM system and your CNC machine. Basically, the plan is to generate the gcode in cambam then run it through the binary converter before sending it to the CNC machine (via floppy disk, it's a very old machine).ĮDIT: I've managed to get it outputting each axis' location on every G line so it will print X and Y coords even if they haven't changed. That part is all under control now and I can probably get that to run post-build processor. Autocad 2013 32 Bit Xforce Keygen featurecam post processor. ![]() The PGM format to XXL format, or, more precisely the binary to text conversion (and vice versa) is done by a separate process. Hi Mitch, Assuming you are using the Parallel Port then it may just be worth checking the voltage between an LPT axis Direction Signal pin and GND (pin 25) whilst jogging that axis in each direction. I imagine they're machine specific and not much cambam can do about it other than maybe insert them verbatim. Re: Heres Delcam Featurecam Mach3 Mill and Turn Post Processors. I'm currently awaiting the machine's documentation (should have it tonight sometime) for explanations of commands like C0 (there's a few others I'm not sure of). ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |